*Imprtant Tip - Replacing a garage door spring can be dangerous. We recommend calling a specialist to handle the job safely—like us!
The Ultimate Guide To Replacing Your Broken Garage Door Spring
Whether you buy springs individually, as a pair, or even in bulk for garage door repair with multiple doors (2+), these ready-to-install supplies will help save time and money on the job. This will provide you with detailed instructions on the steps as how to replace a garage door spring which is damaged and then make your garage door work normal again.
Identifying a Broken Spring
You will need to verify that you actually have a broken garage door spring before proceeding with replacement. First, you will want to take a look at the springs right above your garage door. You show see two springs; one of which may appear to be whole kind, and the second will not. It will often have a gap of one to two inches between the coils or rings so no question as to its need for replacement with this broken spring.
Safety Precautions
When working with garage door springs, safety is the most important aspect. First Disconnect Garage Door Opener Openers opening please unplugged due to it any injuries may be happen automatically during repair. If you have a battery backup system, remove the arm from your garage door to make sure it will not open while you work. Also use vice grips to capture a roller on the track so the door will not go up when you wind those springs.
Unwinding the Unbroken Spring
Before removing anything broken, it is crucial to unwind the unbroken spring. Step 1 Using 7/16" wrench, loosen set screws in one unbroken spring. Using a three eighths socket can greatly speed up this operation. Always use certified winding bars designated for garage door systems to prevent injury.
Approximately 30 quarter turns are necessary to unwind a standard spring. Using slow and alternating between winding bars, release the tension little by little.
Spring winding System Dismantle
Now that our spring is unwound, we can begin to separate the spring system. Stabilize the center poles off and then remove with a 9/16 inch wrench while loosening each of the cable drums. Give the cables a press/pull to check for slack, and make sure they are secure.
Preparing for New Springs
To complete your installation, be sure to smooth down any extra set screw marks on the torsion tube before installing new springs as this will help promote longer life from and smoother operation with the new springs. Install the new springs onto the tube, taking care to place them in their correct positions based off of which design they are (left or right hand).
Installing the New Springs
With the new springs in place, secure them at their center using the OE bolts and a 9/16 inch wrench. You must now mount the new springs and then install your cables. Thread the cables via these notches in addition to appropriately tension them.
Winding the New Springs
Wind the new springs (as per manufacturer specifications) with cables attached on winding bars. This, for an average seven foot door will take 31 quarters turns. Once winding is complete tighten your set screws so they are firmly in place within the hubs
Final Adjustments and Testing
Unclamp the left side of the bar and pull it off; then close your wind here, this moves so fast that you need to be careful. Check That the Garage Door is Balanced by Manually Lifting and Lowering However, if it is heavy or appears to be opening of its own accord you might need to add a little tension in the springs.
Once the door is balanced, connect your garage door opener and test to see how everything works. Now with the door going up and down, make sure it moves without any issues of difficulty
Conclusion
Broken garage door spring - instructions for replacing Heed the guidelines on this step-by-step read, and replace that broken spring while scoring good karma from a handful of garage junkies who wanna thank you for not letting your crappy neighbor shame those hardworking springs. If you experience any obstacles, or are in question regarding while sort of springs should be used on your door system; consult with a qualified garage technician for guidance. Approaching the issue correctly means that your garage door can be both safe and efficient.
To learn more about garage door broken spring replacement cost >>
Or contact us at garage door repair Orange County